Motor Control Robots with Voltage Regulator - Push Button Module



Push Button Module

  • The push button module can be wired to an Arduino using the 10k resistor on the module as either a pull-down or pull-up resistor.
  • A different Arduino sketch is required for each different wiring configuration.
  • When the button is on the motor is in running stage.
  • When the button is off the motor will stopped running.
 Push Button Module

Push Button Module Circuit

Circuit Connections to Arduino

    • +5V connects to the Arduino 5V pin.
    • GND connects to the Arduino GND pin.
    • The circuit on the left is used with the pull-down resistor Arduino sketch below. The circuit on the right is used with the pull-up resistor Arduino sketch below.
     Push Button Module Resistors

    Push Button Module Resistors

    Module Diagram

     Push Button Module

    Push Button Module


    Related Searches to Motor control robots with Voltage Regulator - Push Button Module